Established in 1993, Guanfa Valve Manufacture Co., Ltd. is specialized China inlet valve manufacturer and distributor of valves, hoses, tubes and pipes. Our oem inlet valves are suitable for acid, alkali, water, steam, seawater, coal gas and natural gas. They are widely used in petroleum, chemical, paper making, fertilizer, brewing and metallurgy. The use of specialized software of Pro/E and CAD has shorted the P&D and trial manufacture cycle, and greatly improved the service life and dependability of products. Our high-quality products have been exported to the North Amercia, UK, USA, Germany, Italy, India, France, Australia, Japan.

1/2" standard fill water hole. Prevent siphon design,can insure the water source is clean.
High seal water performance,the water level height is jarless. Low working noise. Adopted POM engineer plastic,long using life. The adjust way of water height is convenient.(Turn the adjustable pole of fill valve deasil or widdershing). Side inlet. Plastic shank G1/2",brass shank G3/8" or plastic shank G3/8" optional. Water level adjustable slightly through moving float bucket up or down. Following Head Sizes available (check your original) : 1.790" or 1.825"
Model 30M stem diameter : 5/16" but could also be used on International. Stem length: 4.875", left blank at end, so can be finished to your engine (standard practice). Use with continuous pilot ignition systems. 24V dual automatic combination valve. The VR8200A 2132 standing pilot, features continous pilot dual automatic valve combination. This unit comes with 1/2" x 1/2" inlet/outlet, has standard opening with pressure regulator setting is 3.5" wc, and has 20-200cfm capacity.

We can offer valves made in China. We also have the sole agency for heavy .We also offer other spare parts used in HOWO & Steyr trucks, such as crankshafts, flywheels, pistons, shock absorbers and rings. We have over ten years' experience in truck industry. Your specific requirements are welcome. Highest quality inlet valves manufactured by G & S Valves. Following Head Sizes available (check your original) : 1.750" or 1.825"
standard Model 30/40 stem diameter : 11/32". Stem length: 4.875", left blank at end, so can be finished to your engine (standard practice). As above, but I have one remaining machined to size, to fit late 30's-40's 'Square' type head. Highest quality inlet valves manufactured by G & S Valves. Dimensions: 1.906" Head Size (approx 1 29/32") x 5/16" stem diameter, as used on late Gardengate Manx heads. Stem length: 4.530", collet grooves finish machined. I advise you check your own valve size to be sure though, these lengths can vary sometimes

Go to China Valve Manufacturer Catalog or China Valve Catalog to find more China Products!