Established in 1993, Guanfa Valve Manufacture Co., Ltd. is specialized China brake valve manufacturer and distributor of valves, hoses, tubes and pipes. Our oem brake valves are suitable for acid, alkali, water, steam, seawater, coal gas and natural gas. They are widely used in petroleum, chemical, paper making, fertilizer, brewing and metallurgy. The use of specialized software of Pro/E and CAD has shorted the P&D and trial manufacture cycle, and greatly improved the service life and dependability of products. Our high-quality products have been exported to the North Amercia, UK, USA, Germany, Italy, India, France, Australia, Japan.

SUZUKI STREET 78-79 GS 750 C/N 8 Valve Rear Brake Pads - SUZUKI STREET 78-79 GS 750 C/N 8 Valve Rear Brake Pads . Our Brake Valve is constructed from brass bar-stock. The valve disk is a lost wax casting of silicon bronze and combined with a Teflon valve seat minimizes by-pass leaking. It comes complete with inlet and outlet unions for 3/16" tube silver solder connections and is ready to install. Vent port is tapped 1/4-28. Spring and screws are stainless steel. Body diameter is 1-1/8". Height is approximately 2". MAX OPERATING PRESSURE:1MPA. OPERATING TEMPERATURE RANGE:-40℃~80℃. OPERATING PRESSURE:800KPA. NPT 3/8". The quick release valve is installed near the brake chambers to facilitate quick release of the air in the brake chambers during brake release. The sealing surface of the butterfly plate is designed into a obliquely sectional conical surface referred to the axis of the butterfly plate to make a touching angle between the sealing surface of the buttery board and the valve seat.

This valve, in 2005 improved vesion can be installed on all planes with hydraulic brakes and allow to brake the plane for parking or to test the engine. The single arm actuates the valve with dual lines for differential braking systems. The design use two gaskets for each way, for double relability. The difference from the old version is that it is not necessery to push on pedals when it is released. just need to turn the lever. 4 treades allow an easy installation. Fittings fits 6 x 4 nulon tube. To fill the reservoirs. To release the spring brake side of the brake chamber. Engage the spring brakes for parking and during emergency situations such as breakaway. A more detailed description can be found in the Tech section About subsection. This is a simplified description and does not take into account service brake operations, specific model features, or additional built in protections. The Gravity proportioning valve is a safety device which is installed at an angle of 45 degrees. What this does is, during sudden braking.

Go to China Valve Manufacturer Catalog or China Valve Catalog to find more China Products!